安全相关的HIMatrix控制器系统可以安装在安装基座上，也可以在封闭的情况下，如控制站、接线盒和控制架。他们已经开发符合适用的EMC、气.候和环境标准要求。这些标准可以在第9章操作条件中找到，也可以在在HIMatrix系统的手册中，必须遵守。HIMatrix设备的防护等级(IP 20)可以通过安装在sui-中来提高表外壳符合具体要求。但是，散热(参见第3.3章)必须检查 装置 所有设备必须安装在水平位置(参考前板)以确保足够的通风。在垂直位置安装需要额外的确保充分通风的措施。有关各种设备的尺寸，请参见相关手册。HIMatrix设备 与其他制造商的设备之间的小距离也至于柜壁如下 ●垂直小100毫米,大约水平。20 mm(由F60的紧固带设定)。还必须考虑安装空间(机架高度),以便连接连接器用于通信的输入和输出(参见第3.2.3章装配高度。 The HIMatrix controller system related to safety can be installed on the installation base or in enclosed situations, such as control stations, junction boxes, and control racks. They have developed compliance with applicable EMC, climate, and environmental standards. These standards can be found in Chapter 9 Operating Conditions or in the manual of the HIMatrix system and must be followed. The protection level (IP 20) of HIMatrix equipment can be improved by installing it in sui - to meet specific requirements. However, heat dissipation (see Chapter 3.3) must be checked device All equipment must be installed in a horizontal position (refer to the front panel) to ensure sufficient ventilation. Installing in a vertical position requires additional measures to ensure adequate ventilation. For the dimensions of various devices, please refer to the relevant manuals. The minimum distance between HIMatrix equipment and other manufacturers' equipment, as well as the cabinet wall, is as follows Vertically smaller than 100mm, approximately horizontal. 20 mm (set by the fastening strap of F60). It is also necessary to consider the installation space (rack height) in order to connect connectors for communication input and output (see Chapter 3.2.3 Assembly Height).
扫一扫咨询微信客服
